![Enviro S50I Owner'S Manual Download Page 17](http://html1.mh-extra.com/html/enviro/s50i/s50i_owners-manual_2415808017.webp)
17
Maintenance And Service
The safety screen mounting position can be adjusted slighlty
to maining paralellism with the fireplace body lines. The outer
standoffs on the lower screen can be repositioned by loosening
the two T20 screws and adjusting via slots, retighten screws.
Figure 24: Safety Screen Adjustments
R
emoving
the
D
ooR
f
Rame
/s
kiRt
The door frame and skirt will need to be removed to gain firebox
and component access. Take care not to scratch any painted
surfaces.
R
emoving
/m
ounting
the
D
ooR
f
Rame
The door frame is attached with four hooks (two on each side) that interlock with slots on the chassis.
Remove:
Lift top plate and set support hinges (see “Lifting The Top Plate” section for details), then grab the
frame on either side and lift up to disengage hooks and bring out.
Mounting:
There are two different sections in each mounting slot (see Figure 25). The door frame should
fit relatively easily into section 1, it may be easier to mount one side first then the other. Once all hooks are
engaged in their respective slots, push in one side of the door frame (top and bottom) until the hooks drop
into the section 2; repeat this on the opposite side. This will firmly lock the door frame into position and close
up any excessive gaps.
NOTE:
If door frame mounting is proving difficult, the curved glass may not be clamped properly creating
and interference with the door frame.
Section 1
Section 2
Section 1
Section 2
Section 1
Section 2
Section 1
Section 2
Figure 25: Chassis Mounting Slots
R
emoving
the
f
Ront
s
kiRt
Remove:
After the door frame is removed, the skirt
can be removed to gain component access by lifting
up at either end to disengage the hooks and brought
out.
Mounting:
Place the skirt hooks into their respective
chassis slots and the center stud support rest in the
finger groove. Ensure proper hook setting is used for
your pedestal option.
The notches closest to the end of the hook should be
used when installed with a pole pedestal. The notches
closest to the body of the skirt should be used when
installed with a wood pedestal (see Figure 27 for de-
tailed view).