Maintenance And Service
c
Leaning
D
ecoRatiVe
s
uRfaces
:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
finish, including cleaners, polish and finger prints. It is important to note that fingerprints and other
marks can leave a permanent stain on plated finishes.
To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the fireplace.
Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
g
Lass
D
ooR
R
emoVaL
:
The door needs to be removed for
sceduled cleaning and to install the
glass media and other options.
To remove the glass door use your
two index fingers to pull the spring
latches up over the two door tabs.
Once release pivot the door to out
and pull it out of the bottom door
retainers. The door must be angled
in order for it to pull out.
To replace the glass door, simply
reverse the above procedure.
Warning:
Do not touch or attempt
to remove the glass door if the
fireplace is not completely cold.
WARNING: Never operate the
fireplace with the glass door
removed.
Figure 9. Bottom Door Retainers
Figure 8. Upper Door Latch
Q2 (DV33) - R04 GLASS TEST
WEIGHT:
A4
SHEET 1 OF 1
SCALE:1:20
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
A
Q2 (DV33) - R04 GLASS TEST
WEIGHT:
A4
SHEET 1 OF 1
SCALE:1:20
DWG NO.
TITLE:
REVISION
DO NOT SCALE DRAWING
MATERIAL:
DATE
SIGNATURE
NAME
DEBUR AND
BREAK SHARP
EDGES
FINISH:
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
Q.A
MFG
APPV'D
CHK'D
DRAWN
Page 11
