7
REMOVING YOUR NEW STOVE FROM THE PALLET
To remove your new stove from its pallet, open the left and right side panels. There are two wood screws that are
holding the bottom of the stove to the pallet. Remove the screws. Close the side panels.
To remove the right and left hand cabinet sides there
are three T-20 Torx screws on the back of the panel,
loosen these screws only.
Remove the one screw located on the front of the
cabinet side located behind the top louvers.
Remove the two wood screws (one on either side of
the unit) to remove the unit from the pallet.
HEARTH PAD PEDESTAL INSTALLATION
Carefully place the back of the pellet appliance on the pallet and install the hearth pad. Align the holes in the
hearth pad and the unit and install the four screws provided.
Place the unit on its back and install the hearth pad using the four screws provided
This unit can be installed on a
combustible floor due to the built in
pedestal hearth pad, for example
linoleum, hardwood flooring. If this unit
is to install onto a carpeted surface a
hearth pad must be used for stability.
This unit is supplied with 4 leveling legs
for uneven surfaces. Adjust these
leveling legs until unit is level.
LEVELING LEGS
X 4
Summary of Contents for EF-V EVOLUTION
Page 30: ...30 WIRING DIAGRAM...
