15
EXTERIOR MOUNTED EXHAUST BLOWER
The
EF V EVOLUTION
can be equipped with an externally mounted exhaust blower.
This optional kit would include all components necessary to install the exhaust blower on any vertical wall surface.
Choose a location for your stove that meets the requirements stated in this manual and allows installation with the
least amount of interference to house framing, plumbing, wiring, etc.
Included in the exterior mounted exhaust blower kit are:
1---Exhaust blower housing.
1---60
°
degree pipe to stove adapter.
1. Remove the left hand cabinet side by removing
(1) one screw between the top louvers. Loosen the three screws on the back of the cabinet side and
remove panel.
2. Loosen the four screws that hold the top back grill in place. Lift the back grill off the screws and remove
NOTE:
Remove the knock out to the lower right of the oval hole. This will be the new chimney location.
3. Remove the two small sections of exhaust
pipe from the exhaust blower.
4. Discard the middle section of exhaust pipe
5. Re install the exhaust pipe marked # 1 to
exhaust blower and remove the exhaust
blower from the unit by undoing the (5) five
bolts the secure the blower to the housing.
6. Install the 60
°
deg pipe to stove adapter to
the exhaust channel in place of the exhaust
blower.
60
°
DEGREE PIPE TO STOVE ADAPTER
INSTALLED TO EXHAUST CHANNEL.
Summary of Contents for EF-V EVOLUTION
Page 30: ...30 WIRING DIAGRAM...
