11
10
Maintenance And Service
c
Leaning
t
he
g
Lass
:
When the fireplace has cooled
, remove the face of the fireplace along with the glass. See
M
aintenance
a
nd
S
ervice
- G
laSS
d
oor
r
eMoval
.
Check the gasket material on the back of the glass, making sure that
it is attached and intact.
During a cold start up, condensation will sometimes form on the glass. This is a normal condition with all
fireplaces. However, this condensation can allow dust and lint to cling to the glass surface. Initial paint
curing of the appliance can leave a slight film behind the glass, a temporary problem. The glass will need
cleaning about two weeks after installation.
Use a mild glass cleaner and a soft cloth
.
Abrasive
cleaners will damage the glass and painted surfaces.
Depending on the amount of use, the glass
should require cleaning no more than two or three times a season.
Do not clean the glass when it is
hot.
c
Leaning
t
he
f
iRebox
:
Remove the logs carefully, as they are very fragile. Carefully clean any dust off the logs and remove
any lint from the burner and pilot. At this time, inspect the ceramic burner for cracking. If a problem is
suspected, contact the dealer. Check the logs for deterioration or large amounts of soot; a small amount
on the bottom side of the logs is normal. Replace the logs as shown in the
S
econdary
i
nStallation
- l
oG
S
et
i
nStallation
section. If any logs are damaged, contact your nearest ENVIRO dealer.
R
ePLacing
the
g
Lass
:
The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory
replacement is required (see
P
artS
l
iSt
). Wear gloves when handling damaged glass door assembly
to prevent personal injury. Do not operate with the glass front removed, cracked or broken. Removal
and replacement of the glass from the door
must
be done by a licensed or qualified service person.
The glass must be purchased from an ENVIRO dealer. No substitute materials are allowed.
Remove the door (see page 12). The replacement glass will come with a new gasket installed. Remove
any silicone remnants from the door. Apply high temperature silicone to the two vertical faces of the
door and install the new piece of glass with gasket (be sure to maintain edge clearances). Apply even
pressure to the glass to allow the silicone to adhere to the gasket material.
f
Lashout
g
uaRD
:
This unit is equipped with a flashout guard that automatically stands up to serve as protection if a delayed
ignition were ever to occur. The flashout guard should always be in the down position (Figure 8) during
regular operation of the stove. If the guard is for some reason left in the up position (Figure 9) it will
effect the volume of convective air discharging from the front of the stove and must be reset to the down
position.
Guard Down
Guard Up
Figure 8: Flashout Guard Down (Default)
Figure 9: Flashout Guard Up
