envea STACK 602, User Manual

Page: 6 / 68

STACK 602
vi
(PC-000848-MA Issue 5, December 2021)
ENVEA UK Ltd
5.2.4 Setting up the Air Purges ................................................................. 29
5.3 Connecting the Transmitter (Tx) ................................................................ 29
5.3.1 Transmitter/Receiver Connections ..................................................... 30
5.3.2 Transmitter/Receiver Link Settings ................................................... 30
5.4 Connecting the Receiver (Rx) .................................................................... 31
5.4.1 Data Cable Connection .................................................................... 32
5.5 Setting up the Receiver ............................................................................ 33
5.5.1 Bus Termination Switch (SW101) ...................................................... 33
5.5.2 Set Address Switch (SW201) ............................................................ 33
5.5.3 Set Comms Settings (SW200) .......................................................... 34
6.
BASIC SYSTEM SETUP ______________________________________ 35
6.1 User Controls and Functionality ................................................................. 35
6.1.1 The ProController UI ....................................................................... 35
6.1.2 The Standard Controller UI .............................................................. 36
6.2 ProController – Function Keys and Setup .................................................... 37
6.3 Main Menu Screens .................................................................................. 37
6.3.1 Other Symbols ............................................................................... 38
7.
INITIAL SETUP ___________________________________________ 39
7.1 Introduction ............................................................................................ 39
7.2 Power-up Checks ..................................................................................... 39
7.2.1 Checking the Comms Mode .............................................................. 39
7.2.2 Performing a Master Reset ............................................................... 39
7.3 Adding Sensors ....................................................................................... 40
7.3.1 Detecting Devices Automatically (Autodetect) .................................... 40
7.4 Editing Basic Sensor Settings .................................................................... 41
7.4.1 Sensor Channels ............................................................................. 42
7.5 Adjust Sensor Brightness and Sensitivity .................................................... 42
7.5.1 Adjusting Sensitivity/Brightness Automatically (Autoset) ..................... 42
7.5.2 Adjusting Brightness and Sensitivity Manually .................................... 43
7.6 Calibration Factor (Cal Factor) ................................................................... 44
7.6.1 Advanced Settings .......................................................................... 44
8.
QUALITY ASSURANCE AND SELF-TESTS ________________________ 45
8.1 Available Sensor Tests ............................................................................. 45
8.1.1 Performing Sensor Self-Tests ........................................................... 45
8.1.2 Sensor Test Pass Levels ................................................................... 45
8.2 Opacity Self-Tests ................................................................................... 46
8.2.1 Viewing Opacity Self-Tests ............................................................... 46
8.3 Dynamic Opacity (Dust) Self-Tests ............................................................ 47
8.3.1 About DynamicOpacity
®
Self-Tests.................................................... 47
8.3.2 Viewing Dynamic Opacity Self-Tests .................................................. 47
8.4 Setting Sensor Tests and Alarms ............................................................... 48
8.4.1 Enabling/disabling Self-Tests ............................................................ 48
8.4.2 Enabling/disabling Self-Test Alarms .................................................. 48
9.
MAINTENANCE ____________________________________________ 49
9.1 Safety Information .................................................................................. 49
9.2 Maintenance Mode ................................................................................... 49
9.2.1 Placing a Sensor in Maintenance Mode ............................................... 50
9.3 Service Messages .................................................................................... 51
9.4 Inspecting and Cleaning Procedures ........................................................... 52