PIXELATOR (70060)
Visit the ENTTEC website for the latest version.
..
USER MANUAL
6
|
ID: 2114
Hardware version: RevC
Document Updated: May 2021
Each PLINK INJECTOR can then be wired up to 3m (total cable length) away from the first Pixel. The PLINK
INJECTOR can drive up to 340 RGB individual pixels (2 DMX universes) - PLINK 2U module must be used in
PIXELATOR Profile.
The PIXELATOR can control a range of SPI (Pixel) protocols, a full list can be found on our website.
PLINK Data:
The PIXELATOR converts Art-Net, sACN, ESP and KiNet into our own PLINK data, which over Cat6
cable can run up to 300m to a PLINK INJECTOR, where it is converted to the SPI (Pixel) protocol.
PLINK Data Pinout:
PLINK Data is sent over Cat6 cable using 3 pins of an RJ45 connector. These pins are:
Pin 1: Data +
Pin 2: Data -
Pin 7: 0V
Hardware features
24* PLINK Output (RJ-45)
1* LAN port (RJ45)
1* DB9 Connector (un-used)
2* USB Ports (un-used)
LCD Menu
The LCD Menu is navigated through the four panel buttons on the front of the unit.
The Menu button acts as the “Back” button, which takes you to the previous Menu/screen.
The Enter button goes into the selected option on the screen and activating the option.
The Top & Bottom button are used to navigate/scroll through the options on any screen. The currently
selected option is highlighted with a white background on the screen.
Main Menu
Line1:
Displays the System Name and currently Selected Profile.
Line2:
Displays the network status of the PIXELATOR. If a connection is made, the PIXELATOR’s IP address
(DHCP or Static) will be shown, this address can be used to access the web interface. If no connection is
made, a message would display as DHCP Failed or disconnected.
Line3:
Displays the number of packets currently passing through the PIXELATOR. This number of packets
per second, can be used as an indicator of the activity on your network.
Pressing any of the panel buttons/keys will activate the Selection Menu.
