PIXELATOR (70060)
Visit the ENTTEC website for the latest version.
..
USER MANUAL
10
|
ID: 2114
Hardware version: RevC
Document Updated: May 2021
Profiles
Within this window you can create, manage, and
activate Profiles within the PIXELATOR. Profiles
allow you to configure that Data is sent to the 24
outputs, as well as allowing you to change
between profiles during the installation if
required.
The PIXELATOR comes with some Read-Only
profiles on the PIXELATOR as default, these will be
displayed within the ‘Remarks’ column. These will
reappear after a Factory Reset.
Use the radio button under the ‘Active’ column to select a Profile to use the functionality along the bottom
of the page. Clicking on the Profile name will launch the profile in the profile editor window.
Profile Editor:
Create a new profile or edit an existing one
using the profile-editor. Profile Editor opens in
a new page in your web browser. Select a
module on the left and the right panel will
provide help about that panel. Connect a
module to another using wires from one point
to another.
The direction of the wire (arrow) is important,
the arrow signifies output, and reflects the
flow of data. The same PLINK port# cannot be
re-used within the same profile.
Profile Modules:
Each profile is made up of two or more connected Modules or Actions. The relationship between them
forms the layout of the data flow within the profile. The following modules are available:
PLINK 1U:
The PLINK 1U module represents one of the physical ports on the rear of this unit, and maps
to 1 Universe. Within this Module you will need to select:
□
Protocol:
select the led protocol that the pixel tape conforms to.
□
Ordering:
RGB or RGBW mapping that the pixel tape conforms to. RGB modes
use 3 DMX slots per LED pixel, and RGBW modes use 4 DMX slots.
□
Grouping:
it allows one DMX pixel to drive multiple physical LED pixels
□
Start-Ch:
DMX Start Channel for the 1st pixel can be changed as needed.
PLINK 2U:
The PLINK 2U module represents one of the physical ports on the rear of this unit, and maps
to 2 Universe. Within this Module you will need to select:
□
Each PLINK 2U module has 2 input nodes that can be connected to two
Ethernet streams. Top one (U1) is mapped to the First universe and Bottom
one (U2) is mapped to the Second universe relative to the pixel-tape.
□
Protocol: select the led protocol that the pixel tape conforms to.
□
Ordering: RGB or RGBW mapping that the pixel tape conforms to.
