PIXELATOR (70060)
Visit the ENTTEC website for the latest version.
..
USER MANUAL
11
|
ID: 2114
Hardware version: RevC
Document Updated: May 2021
Art-Net Stream:
"Send IP address": is the destination address used when the
stream is sending data only.
ESP Stream:
ENTTEC Show protocol DMX over Ethernet stream (ESP).
Kinet Stream:
For example: You can connect Kinet Stream to an Art-Net Stream
to convert and output as Art-Net. (Kinet stream is supported as input only).
Streaming ACN:
"IP address" is the destination address used when the stream
is sending data only (default is disabled = 0.0.0.0)
DMX Generator:
Define your own custom DMX Channel values and assign the
selected ones. Snapshot feature can be used to capture values from an input
stream. All modifications can be done using the DMX Grid Page.
Clock:
Allows you to synchronize ALL Pixel Link output only when the connected Input Stream is received.
The Clock module can be used to make sure the output is always synced to the “latest universe” -
especially if the source adds a delay to each universe.
□
Auto-repeat allows user to repeat the output once every "number of
seconds" regardless of Synced Stream
□
Default behavior [Auto-repeat = Never]: Will only refresh Pixe Link when
Synced Stream is received
Settings / Firmware Update
The PIXELATOR’s settings can be configured within the Settings tab.
Firmware Update:
The latest firmware can be downloaded
from our website. Using the Choose File button, browse on
your local drive for downloaded PIXELATOR firmware file, this
will have a .bin extension. Next click on the Update Firmware
button to begin updating.
Note: Updating the firmware will cause the PIXELATOR’s
normal operation to stop.
After the firmware has updated the PIXELATOR will reboot to
allow the changes to take place. Please see the LCD screen on
the front of the PIXELATOR to see the IP address of the unit.
System Name:
The name will be discoverable within Poll replies. This needs to be saved for the change to
take effect.
Hovering Help:
Help screens can be Enabled/Disabled depending on if you want to see the help pop ups.
This needs to be saved for the changes to take effect.
Network Interface:
Here you can change the Network settings to either Enable/Disable DHCP, or to set a
Static IP address including Net Mask and optional Gateway. When DHCP is enabled, the DHCP server on the
network is expected to automatically provide the IP address to the PIXELATOR. If no DHCP router/server is
present or DHCP is disabled, the PIXELATOR will fall back to the static IP address. Any changes will need to
