WS=All.. The screen should now look like this:
NAME OF INST LYR=A WS=ALL
Now select the wavesample to send to the OEX-6 by
either pressing a key on the keyboard designated for
that wavesample, or scroll (using
Up/Down Arrows
buttons or
Data Entry Slider)
to the desired
wavesample number. Let’s assume we are editing/
sending wavesample 16. The display should now look
like this:
NAME OF INST LYR=A
WS=16
l
Press
Edit,
then
Amp.
This page shows you the output
parameters of the instrument, layer, or in this case, the
wavesample. Scroll through the different parameters
until you see this display:
OUT=FX1
JUST REVERB
This is the page allows you to assign the selected
wavesample 16 (layer or instrument) to the appropriate
bus. We will assign WS 16 to BUS 2.
l
Scroll through choices, you should see FX- 1 (signal
with effects direct to main stereo outputs), AUX 1
(direct dry stereo output), BUS 2 and BUS 3 (direct dry
stereo output to expander and/or signal with effects to
main stereo outputs).
Scroll back to BUS 2 and stop temporarily. The display
should look like this:
OUT=BUS 2
If the display shows an effects description like:
OUT=BUS2 REVERB
it means that the signal on BUS 2 is being routed
