OEX-6sr Operation Manual
Using the OEX-6sr with the EPS-16 PLUS
The EPS- 16 PLUS can route a single wavesample, layer, or
Instrument/Track to any of the outputs. The procedure for each is
similar.
1) Setting up EPS-16 PLUS for use with OEX-6.
l
Connect OEX-6 to EPS- 16 PLUS using previous
instructions.
l
Turn on EPS- 16 PLUS.
l
Press
Edit,
then
System*MIDI.
Scroll to the FX SEND
page the display should look like this:
FX SEND BUS 2=ON
BUS 3=ON
This shows you that BUS 2 and 3 are routed through
the effects processor to the main stereo outputs of the
EPS-16 PLUS. This is not the best way to configure
the machine when using the OEX-6, so we suggest
turning those busses OFF. Scroll to BUS 2=ON and
use the
Up/Down Arrows
or the
Data Entry Slider
to
change to it OFF. Repeat this procedure for BUS 3.
The display should now look like this:
FX SEND BUS 2=OFF BUS 3=OFF
Now any sounds routed to BUS 2 or BUS 3 will appear
only at the OEX-6 outputs, not the main stereo outputs.
2) Assigning a wavesample (layer, instrument/track) to an
OEX-6 Stereo Output, (BUS 2).
l
Load an Instrument.
l
Select the Instrument.
l
Press
Edit.
You should see the following:
NAME OF INST LYR=A WS=ALL
This screen show whether an instrument, layer, or
wavesample is selected for editing. The selection is
underlined. Since we would like to edit an individual
wavesample, scroll (using arrows) to underline
1 3
