OEX-6sr Operation Manual
(included) in the position marked by your masking tape.
Remember to remove the masking tape and discard. Then
place the “hook” side of the velcro strips on the bottom of
the OEX-6sr. Use your thumb to apply pressure to all
velcro strips to ensure a secure fit. Keep in mind, that it
could be difficult to remove the velcro from the front panel
of the ASR/EPS- 16 PLUS at a later time.
You should now be able to place your OEX-6sr on the velcro strips
and have it remain in position. We suggest cleaning the velcro
strips periodically to maintain a secure fit.
Rubber Feet and Velcro Mount
Here’s what you’ll need to get started:
1)
2)
3)
l
OEX-6sr Output Expander
l
Six foot connection cable (cable lengths of 10 feet or
longer may not give optimal results, and are not
recommended by ENSONIQ)
l
Four rubber feet (included)
l
Two strips of adhesive velcro (included)
It is also possible to mount the
OEX-6sr with a combination of
rubber feet and velcro. Apply
the rubber feet to the bottom
front of the OEX-6sr as shown
in the illustration.
Mark a location on the upper
right hand lip of the ASR/
EPS-16 PLUS. This is
where your velcro will be
positioned (the velcro is
mounted horizontally in this application).
Place the “furry” side of the two adhesive velcro strips
(included) in the position marked by the masking tape.
Remember to remove the masking tape and discard. Then
place the “hook” side of the two velcro strips on the bottom
of the OEX-6sr. Use your thumb to apply pressure to all
velcro strips to ensure a secure fit.
3
