www.ensembledesigns.com
Page 79
BrightEye NXT 450 Clean Streaming Router
Installation, Configuration and Operations Guide
Enabling the Unicast A Streaming Output
The streaming output must be enabled before it can send the
output.
1. Press the Configuration button. The top level menus display.
2. Use the up and down arrows to highlight the Unicast A
configuration menu.
3. Press the right arrow button (or OK) to highlight the Enable
submenu.
4. Press the right arrow button (or OK) to go to the Enable
selection menu.
5. Use the up or down arrow button to select On.
6. Press OK to set your new selection, or press the Configuration
button to cancel.
Select the Streaming Source
After configuring the settings of the High Resolution Encoder or the
Low Resolution Encoder, select which of these encoders you want to
use for streaming from the Unicast A Source menu.
1. While in the Unicast A configuration menu, press the down
arrow button to navigate to the Source submenu.
2. Press the right arrow button (or OK) to go to the Source
selection menu.
3. Use the up or down arrow button to select High Resolution or
Low Resolution.
4. Press OK to confirm your setting, or press the Configuration
button to cancel.
Configuring Streaming from the Front Panel Menus
The configuration parameters for Unicast A and Unicast B are identical. The following steps are for
setting up streaming for the Unicast A output.
