Model 7910 HD Upconverter And Cross Converter
Use the
Aud Delay
menu shown below for the 8415 Audio submodule to adjust the
amount of audio delay on the output:
•
Auto Track
– enable auto tracking by selecting
On
or
Off.
•
Bulk Delay
– set the amount of bulk delay using the left and right arrows or enter
a value in the
msec
field with the pop-up keypad and press the
Enter
key.
The amount of total delay will be reported in msec in the
Total Delay
window.
Use the
Aud In A
menu shown on the next page to adjust the following parameters:
•
1/2 Input
– select the input audio source for Input 1/2.
•
3/4 Input
– select the input audio source for Input 3/4.
When an AES input pair is selected as an input, the corresponding AES BNC on
the rear of the module will become an input. If an AES input is not selected, the
corresponding BNC on the rear of the module will automatically become an output.
Refer to the block diagram on page 4 for an illustration of the input/output BNCs.
•
1/2 Mode
– for a Serial input with embedded audio, select the type of audio in the
stream:
•
Audio
– the embedded stream is standard audio.
•
Data
– the embedded stream is a non-audio signal.
•
Auto
– the module will detect the type of signal embedded in the stream,
audio or data.
•
3/4 Mode
– select the type of audio in the serial stream as described above.
•
DeMux Group
– select the embedded audio group to demultiplex from the selec-
tions. The status of embedded audio is shown in the
Embed In
view.
7910-34
