Model 7910 HD Upconverter And Cross Converter
MODULE CONFIGURATION AND CONTROL
The configuration parameters for each Avenue module must be selected after installation.
This can be done remotely using one of the Avenue remote control options, or locally using
the module front panel controls. Each module has a
Remote/Local
switch on the front
edge of the circuit board which must first be set to the desired control mode.
Configuration parameter choices for the module differ between
Remote
and
Local
modes.
In
Remote
mode, choices are made through software and allow more selections. The
7910
Parameter Table
on page 9 summarizes and compares the various configuration
parameters that can be set remotely or locally and the default/factory settings. It also
shows the default User Levels for each control. These levels can be changed using the
Avenue PC application
If you are not using a remote control option, the module parameters must be configured
from the front panel switches. Parameters that have no front panel control will be set to a
default value. The
Local
switches are illustrated in the
Front Panel Controls and
Indicators
section on page 11. The
Local
switches are inactive when the
Remote/Local
switch is in the
Remote
position.
In
Remote
mode, Avenue module parameters can be configured and controlled from one of
the remote control options, the Avenue Touch Screen, Avenue Express Control Panel, or
the Avenue PC Application. Once the module parameters have been set remotely, the
information is stored on the module’s CPU. This allows the module to be moved to a
different slot in the frame at your discretion without losing the stored information.
To set parameters remotely using the Avenue PC option, refer to the
Avenue PC Remote
Configuration
section on page 12.
To set parameters remotely using the Avenue Touch Screen option, refer to the
Avenue
Touch Screen Remote Configuration
section on page 23.
Express Panel operation is described in the data pack that accompanies the control panel
option.
7910-10
