IQ Battery 3 wall mount bracket
Bracket shelf
Mounting holes
Front view
Angle view
IQ Battery 3 — single-width bracket
A ) Place the wall-mount bracket on the wall so that the mounting holes
in the middle of the bracket align with the center of the stud.
B ) Use a level to keep the bottom of the wall-mount bracket level.
C ) Use 1/4” screws (or masonry attachments for masonry) to attach
the bracket using one screw and washer for each slot (6.8mm /
0.27”).Tighten all the screws to manufacturer’s specified torque
values.
D ) Verify that the wall-mount bracket is solidly attached to the wall. You
must use four screws in each mounting bracket.
*
WARNING!
Risk of injury and equipment damage. Do not mount
an IQ Battery 3 on a bracket that is not properly mounted.
E ) If installing additional batteries, install adjacent wall-mount brackets,
as needed. Be sure to align the mounting holes in the wall-mount
bracket to the center of the wall stud. You may install another
row of brackets above the one already installed. Maintain at least
15 cm (six inches) vertical clearance between rows of IQ Battery
installations, and ensure that the wall can support the structural
load (weight) of the installation.
*
WARNING!
Risk of injury and equipment damage. Do not install
more than three IQ Battery 3 units per 20A branch circuit.
4
Install the IQ Battery 3 (single width) or IQ Battery 10 (triple
width) wall mount bracket
IQ Battery 10 — triple-width bracket
A ) Place the wall-mount bracket on the wall so that the mounting holes
in the middle of the bracket align with the center of the stud, and the
mounting holes on the left and right align with the adjacent studs.
B ) Use a level to keep the bottom of the wall-mount bracket level.
C ) Use 1/4” screws (or masonry attachments for masonry) to attach the
bracket using one screw and washer for each slot (6.8mm / 0.27”).
Use screws in each section of the mounting bracket to support the
three IQ Battery units. There is an array of slots so that you can
choose those that allow you to mount the bracket on studs. Tighten
all the screws to manufacturer’s specified torque values.
D ) Verify that the wall-mount bracket is solidly attached to the wall.
*
WARNING!
Risk of injury and equipment damage. Do not mount
10 IQ Batteries on a bracket that is not properly mounted.
E ) If installing additional batteries, install adjacent wall-mount brackets,
as needed. Be sure to align the mounting holes in the wall-mount
bracket to the center of the wall stud. You may install another row of
brackets above the one already installed. Maintain at least 15 cm (six
inches) vertical clearance between rows of IQ Battery installations,
and ensure that the wall can support the structural load (weight) of
the installation.
*
WARNING!
Risk of injury and equipment damage. Do not install
more than one IQ Battery 10 unit per 20A branch circuit.
IQ Battery 10 wall mount bracket
Bracket
shelf
Mounting holes
Front view
Angle view
Vertical
+5° Inclination
-5° Inclination
Floor
W
all
W
all
W
all
Allowable tilt from vertical for IQ Battery installation
627 mm
991 mm
6.8 mm
300 mm
627 mm
6.8 mm
Follow the instruction below for the bracket style (single-width or triple-width)
you are installing.
*
WARNING!
Risk of injury and equipment damage. Attach the wall
mount to the wall so that it is no more than five percent from vertical. See
the following image for reference:
