KB Power on Password
Set the keyboard power on password, if you enable this function, you can use the
keyboard to power on the machine with the password you defined, but at the
same time, the machine can’t be power on with the normal power button on the
front panel.
Hot key power on
Set the power on hot key, the function almost the same with the keyboard power on
function.
UART Mode Select
Choose Normal (default), IrDA 1.0, or ASKIR to meet the specification of your Infra
Red device.
RxD, TxD Active
Choose Hi/Hi; Hi/Lo (default); Lo/Hi; or Lo/Lo. Ask your IR provider when you use
this function.
IR Transmission Delay
Choose Enabled or Disabled. Ask your IR provider when you use this function.
USER Password
This Main Menu item lets you configure the system so that a password is
required every time the system boots or an attempt is made to enter the
Setup program. The password cannot be longer than 8 characters.
IDE HDD Auto Detection
If your system has an IDE hard drive, you can use this utility to detect its
parameters and automatically enter them into the Standard CMOS Setup.
Normal mode
For drivers small than 528MB
Large Mode
For drives larger than 528MB that do not use LBA. There can only be used
with MS-Dos operating system.
LBA mode
For drivers larger than 528MB and up to 8.4GB that use logic block
addressing mode. Normally we recommend to select LBA Mode if our HDD
drivers large than 528MB
SAVE & EXIT SETUP
