41
EN
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp
hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the
power cable of the charger out of the mains
socket.
•
If required, allow the device to cool down.
•
Remove the battery from the device (see
Start-up chapter).
•
Clean the device according to the
Maintenance chapter.
•
Store the device according to the Storage
chapter.
7. Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than
those specified in the operating manual may
cause a risk of injury.
Designation
Spare battery
2.0 Ah 20V
151218.01
8. Errors and faults
The device has been checked for proper
functioning several times during production.
If malfunctions occur nonetheless, check the
device according to the following list.
Troubleshooting tasks which require the
housing to be opened must only be carried out
by an authorized specialist electrical company
or by ENKHO.
Slight smoke or odour are emitted during first
use:
•
This is not a fault. These phenomena
disappear after a brief runtime.
The battery does not charge:
•
Check whether the battery is correctly
connected to the quick charger.
Slide the battery into the quick charger in
a way that the battery terminals engage in
the quick charger. The battery must lock in
place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for
damages.
•
Check the fuse (home).
•
Check the quick charger for damages.
Should the quick charger be damaged,
stop using it. Contact the ENKHO customer
service.
•
Check the battery terminals for dirt.
Remove any dirt.
•
The battery might be defective and have to
be replaced. Only use batteries of the same
type.
The device does not start:
•
The battery power might be too low.
Recharge the battery.
•
Check whether the battery is correctly
connected to the device.
Slide the battery onto the device in a way
that the battery terminals engage. The
battery must lock in place in the device.
•
Check the battery terminals for dirt.
Remove any dirt.
Info
Wait for at least 10 minutes before switching
the device back on.
The saw blade is loose:
•
Check the saw blade for tight fit.
•
Check the flange and flange nut for tight fit.
Do not use flanges or flange nuts whose
bore hole is larger or smaller than that of
the saw blade.
The saw blade experiences difficulties
penetrating the material to be processed or
the sawing performance is insufficient:
•
If the saw blade is worn, replace it with a
