42
EN
new one.
•
Check whether the chosen saw blade is
suitable for the material to be processed.
The cutting performance decreases:
•
Check whether the saw blade is suitable for
the application.
•
Keep the saw blade clean. If necessary,
replace worn or damaged saw blades.
•
Resin or glue residues may impair the
quality of the cut.
•
Keep the venting slots clear to prevent the
motor from overheating.
•
Check the charging status of the battery.
The displayed battery capacity might be within
the red range indicating that the battery should
be charged.
The lower guard cannot be opened or is
blocked:
•
Check for material residues and, if any,
remove them. The lower guard must open
and close freely at all times.
The device becomes hot:
•
Check whether the chosen saw blade is
suitable for the task to be carried out.
•
Keep the venting slots clear to prevent the
motor from overheating.
Note
Wait for at least 3 minutes after maintenance
and repair work.
Only then switch the device back on.
Your device still does not operate correctly
after these checks?
Please contact the customer service. If
necessary, bring the device to an authorized
specialist electrical company or to ENKHO for
repair.
9. Maintenance
Activities required before starting
maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with
wet or damp hands.
•
Switch off the device.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing
to be opened must only be carried out by
authorised specialist companies or by
Eurospin.
Notes on maintenance
Inside the device, there are no parts that need
to be maintained or lubricated by the user.
Cleaning
The device should be cleaned before and after
each use.
Note
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories
in water. Make sure that no water or other
liquids can enter the housing.
•
Clean the device with a soft, damp and lint-
free cloth. Ensure that no moisture enters
the housing. Protect electrical components
from moisture. Do not use any aggressive
cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive
cleaners to dampen the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Clean the saw blades immediately after use
to keep them free of resin or glue residues.
•
Keep the connecting terminals on the
device and charger clean.
•
Keep the connecting terminals on the
battery pack clean.
