40
EN
Wear a protective mask.
•
Only use a sharp saw blade suitable for
non-ferrous metals. This guarantees a
clean cut and prevents the saw blade from
getting jammed.
•
Only hold the power tool against the
workpiece when the tool is switched on
and running. Start sawing carefully and
with little forward motion. Continue sawing
with little forward motion and without
interrupting.
•
When sawing narrow profiles, you should
start on the narrow side. When sawing
U-profiles, you should start on the open
side. Long profiles should be supported to
prevent the saw blade from getting jammed
and thus to avoid the risk of a kickback.
Switching the laser on and off (Fig.18)
If required, you can switch on the laser to mark
the cutting line.
Warning of laser radiation Laser
class 2, P max.: < 1 mW,
λ
: 650
nm, EN 60825-1:2014
Do not look directly into the laser
beam or the opening from
which it emerges. Never point the laser beam
at people, animals or reflective surfaces. Even
brief eye contact can lead to eye damage.
Examining the laser output aperture by use
of optical instruments (e.g. magnifying glass,
magnifiers and the like) entails the risk of eye
damage. When working with a laser of class 2,
observe the national regulations on wearing
eye protection.
1. Press the Laser button (2) to switch the
laser on or off.
Switching the device on and off (Fig.19-21)
Wear your personal protective equipment when
working with the device.
1. Check whether the fixed saw blade is
suitable for the intended application.
2. Check whether the workpiece is secured
and the worktop prepared correspondingly.
3. Hold onto the power tool with both hands.
4. Position the device by first placing the front
edge of the base plate on the workpiece.
5. Align the device with the rip fence or the
cutting line.
6. Press the start lock (25) to be able to
actuate the on/off switch (24).
7. Press the on/off switch (24) and hold it
during operation.
- The device operates with the previously
selected settings.
8. Wait a moment until the motor has reached
full speed.
9. Move the device closer to the workpiece.
10. Move the device along the cutting line with
a slight forward motion.
- The lower guard opens automatically
when the device is pushed forward. Do
not open the lower guard manually. Risk
of injury!
11. After completing the sawing operation, let
go of the on/off switch (24) to stop the
device.
Connecting the dust extraction system
You can connect a vacuum cleaner to the
device. The adapter included in the scopeof
delivery allows to connect smaller pipe
diameters. (Fig.22)
Caution
Use a special vacuum cleaner to suck off
harmful or toxic materials.
1. If required, attach the adapter for dust
extration (15) to the chip ejector (7).
2. Connect a suitable vacuum cleaner
industrial vacuum cleaner) to the chip
ejector (7).
Connecting a dust bag (optional)
For small-scale work, you can optionally
connect a dust bag.
1. Insert a suitable dust or chip bag firmly into
the chip ejector (7).
2. Empty the dust bag in due time to
guarantee proper absorption of a sufficient
amount of dust and chips.
