18
17
U
sinG
m
ax
p
anel
m
ax
p
anel
p
aCkaGe
C
ontents
& C
ontrols
6
7
5
2
3
1
8
9
10
11
4
12
13
14
Figure 2
1. Turning the power ON
On the right side of the LCD Power Pack
flip the switch from 0 to l. (See Figure 1)
The LCD screen and Max camera will au-
tomatically turn on in a few seconds.
An image of what the camera is on top of
should appear on the LCD screen.
Turn the power off by flipping the same
switch back to the 0 position. However,
leave the power on for this training section.
Note: If the battery is charged, there is no need to plug in the power
supply and cord. If the battery is not charged, then refer to “Recharg-
ing the Battery” section on page 22.
Figure 3
Figure 4
2. Adjusting the LCD screen
It is important to orient the LCD screen to provide the best viewing
angle. To lift the screen put one hand on the back of the base and the
other hand one the LCD and pull forward (see Figure 2-3). Once in
the upright position use both hands to adjust vertically (see Figure 4).
Figure 1
USing Max panel