Delay Tails
Push and hold the Delay
push button for about 2 seconds until the Delay LED starts to flash. Three
short flashes for Delay Tails active, one long flash for Delay Tails inactive. This adjusted status can
be saved to a MIDI preset.
Gain Boost
Press this push button to activate / deactivate the Gain Boost function. The red LED above this push
button lights up to indicate that the function activated. This feature can also be stored and switched
via MIDI program change or controlled via the respective ENGL Z4 (TRS) footswitch connected.
Clean/Lead Channel
Press this push button to toggle between the Clean and the Lead channel. The red LED above this
push button lights up to indicate that the Lead channel is engaged. This feature can also be stored
and switched via MIDI or controlled via the respective ENGL Z4 (TRS) footswitch connected.
FX Loop
Press this push button to activate / deactivate the FX Loop function. The red LED above this push
button lights up to indicate that the function is activated. This feature can also be stored and
switched via MIDI.
Noise Gate
Press this push button to activate / deactivate the Noise Gate function and suppress excess noise
in the Lead Channel with or without the Gain Boost function engaged. Control the Noise Gate
threshold using the Noise Gate knob on the back of the amp. The red LED above this push button
lights up to indicate that the function is activated. This feature can also be stored and switched via
MIDI program change.
Stand By
Use this switch to silence the amp when you take a longer break. The amp´s tubes stay nice and
toasty, and the amp is ready to roll immediately when you ramp it back up to full power. The Stand
By switch is also well-suited for muting the amp for brief breaks, for instance when you are
switching guitars.
Power
Mains power on/off.
Please note:
ensure that the Stand By switch is set to Stand By before you switch the amp on. Let
the tubes heat up for about 30 seconds before you activate the power amp. This procedure spares
the tubes.
Summary of Contents for Ironball SE E606SE
Page 1: ...E606SE Ironball SE Operator s Manual...
Page 16: ...www engl amps com...
