IR Bypass
Push and hold the FX Loop push button for about 2 seconds until the FX Loop LED starts to flash.
Three short flashes for IR Bypass active, one long flash for IR Bypass inactive. The IR Bypass will be
deactivated by selecting another IR as well. The adjusted status will not be saved to a MIDI preset
but it is globally saved until you change it by holding and pressing the FX Loop push button for about
2 seconds again or moving the IR Selector Switch. Powering the amp off and on will discard the
status to IR Bypass inactive as well.
This feature is very useful, when using the E606SE Ironball Special Edition for a recording session
and you want to use an external IR Loader for example.
IR Balanced Output
Headphone Output
Connect a headphone (3,5mm / 1/8” TRS) for easy monitoring or practice. When selecting the
Power Soak “Speaker Off” position you can practice without disturbing your neighbours.
CAUTION! When powering the amp up, upcoming noise can appear and damage hearing. Make
shure to remove the headphones while powering the device up.
Headphone Level
Adjusts the level of the Headphone output.
XLR – Ground
When this push button is not pressed, the ground is lifted. Push this switch when you recognize
upcoming ground loop noise.
Poweramp Output
1. One 8 - 16 Ohm cabinet connected to the left jack.
2. Two 16 Ohm cabinets connected to the both output jacks.
Important Note:
We cannot stress enough the importance of proper impedance matching when
connecting one or more cabinets to your amp. Impedance mismatching can damage the poweramp!
Always check the connected cabinet´s impedance to confirm it matches the amp´s output
impedance!
Summary of Contents for Ironball SE E606SE
Page 1: ...E606SE Ironball SE Operator s Manual...
Page 16: ...www engl amps com...
