~45~
Call a Caller ID
1. When display a caller ID, Press
or
to dial
this number.
2. The displayed caller ID normally will be a 10-digit
number with a 3-digit area code followed by the 7-digit
telephone number.
The number in call log can be modified to comply with
the local dialing rules.
3. Press
key, use
or
key to scrool the
call log.
4. To display the telephone number without “1” or area
code, press
FORMAT
(Left) soft key.
5. For example, the number stored in the call log is “1-
555-423-1234”, press the
FORMAT
(Left) soft key
once, the displayed number will be changed to “423-
1234”.
Press the
FORMAT
(Left) soft key a second time, it
will be changed to “555-423-1234”.
Press the
FORMAT
(Left) soft key a third time, it will
be changed to original number “1-555-423-1234”.
6. Press
or
to dial this displayed number which
complies with the dialing rules.
Note: Normally the standard format of telephone
number is 10-digit or 11-digit, if the number
doesn’t meet the format (For example, over 11-
digit), then the displayed number will not be
modified as above item 5 when press
FORMAT
(Left) soft key.
Base Speed Dial Setting
1. You can store up to 20 entries in the speed dial memory. Each speed
dial memory can contain a phone number (up to 32 digits).
2. Base during standby mode, press
key, enter the telephone
number.
3. Press
key, followed by a 2-digit memory location, base then will
emit a two short tone (Bi-Bi) to confirm the setting.
~46~
Re: The memory location is “00” ~ “19”.
4. When using the base speed dail, press
key followed by
key, then enter the 2-digit memory location (“00”~”19”).
The base will dial the telephone number accordingly.
Base Ringer Setting
1. You can change the base ringer by following :
2. Base during standby mode, press
key twice, followed by
or
key, the base speaker will emit the varied ringer (up to 8
ringer tones).
3. Press
key to confirm the setting.
4. To adjust the ringer volume, two options can be followed:
a. Base during standby mode, press
or
key.
b. When incoming call, press
or
key.
c. When press
or
key to adjust the volume, the speaker will
emit the loudness of ringer, you can choose the preference.
Re: The loudness level of ringer is “0~4”, “0” means ringer “Off”.
Multi-Base Setting
“Multi-Base” setting allows expanding coverage or lining capacity. When
adding 2
nd
, 3
rd
or 4
th
base, using one of the handsets which registered to the
1
st
base (i.e. the handset with ID 11), followed by below processes
：
1. Press
MENU
, followed by “7” to enter the registration
mode.
2. Press & hold the base REG button for thress seconds,
the base will emit the prompt ringing (also the base
speakerphone & Intercom LED is flashing).
3. Press digit “3” of handset to enter the Multi-Base
mode.
4. Select BS # 1
5. Repeat above step 1 ~ 4 to continuously add the 2
nd
,
3
rd
or 4
th
base.
