22
4.3
WDS Bridge Mode
In WDS Bridge Mode, the EAP300 can wirelessly connect different LANs by configuring the MAC address and security
settings of each EAP300 device. Use this mode when two wired LANs located a small distance apart want to communicate
with each other. The best solution is to use the EAP300 to wirelessly connect two wired LANs, as shown in the following
figure. WDS Bridge Mode can establish four WDS links, creating a star-like network.
Note
: WDS Bridge Mode does not act as an Access Point. Access Points linked by WDS are using the same frequency channel. More Access
Points connected together may lower throughput. This configuration can be susceptible to generate endless network loops in your network,
so it is recommended to enable the Spanning Tree setting (see 6.3 Spanning Tree Setting, below) to prevent this from happening.
Summary of Contents for EAP300
