ENFORCER HDMI Extender over Single Cat5e/6
6
SECO-LARM U.S.A., Inc.
1.
Determine the locations where the MVE-AH1E1-01NQ units will be wired as well as length of
Cat5e/6 cable necessary.
2.
Connect the transmitter to the HDMI output of the source device.
3.
Connect the Cat5e/6 cable to both the receiver and transmitter units.
4.
Connect the receiver to the HDMI input of the display or other device.
5.
Connect one 5VDC adapter to the transmitter and another to the receiver.
6.
Determine which device, if any, will be controlled by the remote control. Install the IR
transmitter to the IR-TX port, pointing the IR transmitter at the device to be controlled. Install
the IR receiver to the IR-RX port of the other device, pointing the IR receiver to where the
remote control will be. Point the remote control at the IR receiver when in use. Use the
included double-sided tape to securely fasten the IR transmitter and IR receiver in the
correct positions.
7.
Switch on the HDMI source and display to verify that the system is functioning properly.
NOTE:
It may be necessary to move the EDID Switch to a different position if the system is
not displaying a correct image.
8.
If the display shows image flickering, blinking, or distortion, use the Equalizer DIP switch to
configure your installation to the correct cable length range.
Installation:
IR Pass-Through:
The MVE-AH1E1-01NQ supports IR pass-through signals to allow for remote operation of the
source device from the display location. The IR transmitter and receiver support a frequency range
between 30~60 kHz.
IR Transmitter
IR Receiver
