ENFORCER HDMI Extender over Single Cat5e/6
8
SECO-LARM U.S.A., Inc.
SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
®
PICHN3
MI_MVE-AH1E1-01NQ_180109.docx
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2018 SECO-LARM U.S.A., Inc. All
rights reserved.
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in normal
service for one (1) year from the date of sale to the original customer. SECO-LARM’s obligation is limited to the repair or
replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if
damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment
is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO-LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing
LLC in the United States and other countries.
Troubleshooting:
Also Available from
SECO-LARM
®
:
HDMI device does not function correctly
Use T568-B wiring standard
Make sure the extender is powered on both sides
Make sure the source and display are powered
Test the Cat5e/6 cable between the receiver and the
transmitter to make sure it is functional
Make sure there are no problems with the HDMI source,
HDMI cables, or HDMI display by plugging the source
directly into the display using an HDMI cable
Screen flickering or brief image loss
Use a higher grade of twisted pair category cable
(Cat6 is recommended)
Switch the source device to a lower HDMI output
(i.e., 1080p to 1080i)
Power down the unit then move the EDID switch to the
opposite position and re-power the unit
Restart the handshake process by powering everything
down then powering up and connecting each device in
succession starting with the HDMI source
HDMI Extender over
Single Cat5e/6
HDMI Extender over
Dual Cat5e/6
High-Speed
HDMI Cables
MVE-AH030Q MVE-AH010Q
MC-1130-xxFQ
