6
6.3 The wire leads of wind turbine and connection wires of battery should refer to wire
requirement and regulations:
6.4 Please read carefully about controller instructions to set the functions after the completion
of system wiring, such as model selection and regular time setting:
6.5 PV charging debug: in the light condition (output voltage of solar panel is greater than that
of battery), the controller's PV indicator should be working (normal on or linking), measure
output current by DC clamp meter, the current size depends on illumination intensity and
battery capacity;
6.6 Wind turbine charging debug: wind turbine operation is normal or not when it is windy,
while reach or exceed cut-in wind speed, the controllers wind turbine indicator should be
working (normal on or blinking), measure output current by AC clamp meter, the current size
depends on wind speed and battery capacity:
6.7 Light-control function debug: measure battery voltage by multimetre to ensure battery
voltage is higher than over discharge recovery voltage, then set to light-control mode, discon-
nect any wire of solar panel from controler, several minutes later, observe whether the light of
loads is on or not, it is normal it the light is on. Then connect the solar panel wire with control-
ler again. the load output is cut off a few minutes later and the light goes out:
6.8 Time-control function debug: ensure battery voltage is higher than over discharge recov-
ery voltage, observe whether the lighting time of load output light is the same as that of
setting.
7 Maintenance
Although your high reliabity of wind turbine baa been designed to run for long periods with-
out requiring any maintenance, reliability and performance will be enhanced if you periodical-
ly inspect your system.
The following situations need regular maintenance:
Maintenance item
Check the rope tightness of tower
Check the working condition of the whole
system and connector tightness
Maintain battery (refer to battery manual)
Check all electrical connections to make sure
they are tight and free from corrosion
Wash off any built-up dirt or debris from the
blades and check blades for chip or nicks
Check damaged degree of nosecone
Replace blades
Replace battery
After
storm
Every
six
months
Every
year
Every
two
years
Every
five
years
Summary of Contents for GE-600-24
Page 1: ...GE 600 24 USER MANUAL...
