8.7 Solar output voltage too low or no output in wind and solar hybrid system
Check whether solar panel lead is short circuit. circuit break. open circuit or not.
8.8 Light source is not on in wind and solar hybrid system
This situation is mainly cause by:
1. Light source is damaged and need to be replaced;
2. Battery is under voltage, controller does not supply power, which is system normal protec-
tion;
3. Controller is burned out and needs to be replaced;
4. The mode setting on the controller is not correct and needs to be reset according to
controller manual.
8.9 Wind turbine does not charge battery
This situation is mainly cursed by:
1. Wind speed is too small to reach cut in state, output DC voltage of wind turbine is lower
than battery voltage;
2. Type ot battery is not matched with controller, battery should be replaced (commonly use
lead acid battery);
3. Burning of controller results in not charging battery, controller should be replaced;
4. Battery is fully charged, controller is over-voltage protection.
8
Summary of Contents for GE-600-24
Page 1: ...GE 600 24 USER MANUAL...
