67
0120011-J0 Rev M
7�6 Replacing an Alarm Relay Module (19"/23" only)
The following two procedures cover how to replace an alarm relay for shelves with or without the CXCI+ controller.
The system is operational even without the controller during the alarm relay interface board change.
1. Remove the controller using the steps for 'Replacing the Controller” in section .7.4.
2. Leave the locking tab in the ‘unlock” position (pushed all the way to the left).
3. Unwind the 2 screws shown in a counterclockwise direction, using a stubby Phillips driver.
ATTENTION!! Keep the screws for the replacement kit.
4. Remove the two screws and then slowly slide the entire interface bracket out for about 2 inches. At this
distance, the ribbon cable (not shown) should still maintain some slack.
Summary of Contents for alpha LPS36
Page 1: ...LPS36 Line Power System Technical Guide 0120011 J0 Effective 07 2020...
Page 2: ......
Page 4: ......
Page 85: ......
