6
Doc
L4540
_a
Failure to observe and comply with the following
precautions could result in property damage and/or
void the product warranty.
• In severe service conditions, be aware that the
EVOP system must be inspected, cleaned and
lubricated more frequently than normal.
• If oil leakage is present, replace seals as required
before placing the tool back into service.
• If any tool is dropped from a significant height,
have it inspected and checked for proper operation
before placing it back into service.
• While moving the hoses, prevent the couplings
being dragged over the ground.
• Always follow the inspection and maintenance
instructions contained in this manual. Perform
maintenance and inspection activities at the
specified time intervals.
• Hydraulic equipment must only be serviced by a
qualified hydraulic technician. For repair service,
contact the Enerpac Authorized Service Center in
your area.
• To help ensure proper operation and best
performance, use of Enerpac oil is strongly
recommended.
2. Compliance
Statement
2.1 EU Declaration of Conformity
Enerpac declares that this product has been tested and
conforms to applicable standards and is compatible to
all CE Requirements.
A copy of an EU Declaration of Conformity is enclosed
with each shipment of this product.
2.2 UL Certification
Enerpac declares that all electrical components used on
Enerpac EVOP12140, EVOP140150 and EVOP180150
carry the UL508A Industrial Control Panels.
NOTICE
These tools conform with the
requirements for CE.
•EVOP12140W/J •EVOP140150W/J •EVOP180150W/J
3. Introduction
3.1 Overview
The Pump Per point Lift System (EVOP) enables control
movement of one lifting point remotely. The load can be
lifted/lowered using single or double-acting cylinders or
even for pulling cylinders.
Depending on the application, the EVOP can be operated
individually or simultaneously in a synchronously mode
with a Coordinated Lifting Network Controller (refer to
controller’s instruction sheet for more detail information).
This network controller can remotely control up to 12
EVOPs. In this way, the connection capacity of lifting or
lowering points is increased, maintaining the precision
and characteristics as a single unit. The synchronization
can be obtained by motor inverters or by electrovalves.
Built in warning and stop alarms for optimum safety,
EVOP has a great accuracy of the cylinder position due
to each cylinder having a dedicated powerpack.
3.2 Application
The EVOP can be used in a wide variety of lifting,
lowering and pushing applications, such as: bridge
deck lifting for bearing maintenance, machinery lifting
and moving, skidding to move structures and buildings,
and shipbuilding applications.
3.3 Delivery Instructions
Upon delivery all components must be inspected for
damage incurred during shipping. If damage is found
the carrier should be notified at once. Shipping damage
is not covered by the Enerpac warranty. The carrier is
responsible for all repair and replacement costs resulting
from damage in shipment.
4. Transport
The frame has two forklift truck pockets for forklift lift, and
four hoisting certified eyes for lifting with cranes.
Industrial Control Panel
Fabricator
Figure 1: Transport Frame
