Eneo ENC-501L, Installation And Operating Manual

Page: 39 / 72

38 39
1. Select a Speed Dome device Model from the drop-down list on the Speed Dome Controller.
The Controller will display the corresponding Model.
2. Select a Speed Dome device ID from the drop-down list on the Speed Dome Controller.
The Controller will display the corresponding ID.
3. Each of the ten buttons under ‚Set’ is connected with a specific position and angle of either panning or tilting
of the camera. Click each button to activate its particular position and angle. Press the button under ‚Preset’ to
turn the camera angle by angle in the set positions. Each of the ten buttons designated ‚Go to’ can be clicked to
view the particular corresponding angle of the position in which it is set.
4. Select the connecting port. The RS-232 communication port functions as a connector to an external control
device. The RS-485 communication ports function as connectors when two or more units are serially connected
to an external control device.
5. Upon the buttons being clicked, a camera will move one short step only in any of the four designated directions.
6. Click the buttons to control the Focus setting on the Speed Dome Controller. Click „
+ ” button to focus far and
click the „
–
” button to focus near.
7. Click the buttons to control the Zoom setting on the Speed Dome Controller. Click „ + ” button to zoom in and
click the „
–
” button to zoom out.
8. Upon the buttons being clicked, a camera will turn all the way, without stopping, in one of the four designated
directions.
9. Click the buttons to control the Aperture setting on the Speed Dome Controller.
5.1.7 Change the Pan/Tilt setting
Click the Pan/Tilt button on the home page to open the Speed Dome Controller.