Eneo ENC-501L, Installation And Operating Manual

Page: 11 / 72

10 11
Warning:
1. Don’t use FAT32 or NTFS or other file formats in Step 1.
2. Step 1 to Step 3 have to be done on a PC.
3. Make sure the file of UPDATE.BIN is a correct one in Step 3, or LANCAM will not work normally after
updated.
4. If the power of LANCAM is suddenly lost in Step 8, please remove the SD Card first and power on LANCAM
next for testing its operation. If LANCAM remains working normally, please go back to Step 4; oppositely,
please inform your technical support.
5. In Step 10, if the SD Card is not removed and LANCAM dose not get online as well, the update process will
repeat again after rebooting LANCAM.
6. Make sure that the SD Card is inserted with a correct position in Step 5, or LANCAM will suffer permanent
physical damage.
7. If „CSUM ERROR” appears in Step 8, it implies a problem on the file of UPDATE.BIN.
8. Don’t Interrupt the process while the unit is updating itself and proceed with a SD card containing with
no system software of the unit, which would cause the unit hang on.
3.5 LAN CAMERA SD CARD TROUBLESHOOTING
1. Check out the SD Card position whether it is correct. Please refer to the manual for the related information.
2. After powering on LAN CAMERA, insert SD Card with a correct position and then, a little icon of „SD” will show up
in the upper-right corner of the screen of a monitor. If not, it means the device detection fails.
Please contact your technical support and ignore the following steps.
3. If no cross sign appears beside the „SD” icon, please go forward to the next step. If a cross sign appears, please
check out the followings:
a. Is it really a SD „Memory” Card ?
b. Is this SD Card formatted with the FAT16 format ?
c. Connect the SD Card with a PC and, test whether the PC can read the data or not ?
d. Dose this SD Card still have capacity for storing data ?
e. Is the SD Card set to be writable ?
If all the answers are „yes” but the cross sign still exists, please contact your technical support and ignore the
following steps.
4. Please make sure the function of „SD CARD ENABLE” is enabled on ALARM and SCHEDULE pages if no cross sign
appears beside the „SD” icon on the screen.
5. After recording, read the data through web page of „sdget.htm”. If the data cannot be read through networks,
please read it by a PC instead and check out the data stored in „LANCAM” directory and, please contact your
technical support no matter there is data or not.