49
automatically. Only the same basic configuration, the same rate and duplex attributes,
connected to the same device, and the opposite port also meet the above conditions, can
be dynamically brought together. Even if only one port can create dynamic aggregation, this
time for the single-port aggregation. Dynamic aggregation, the port LACP protocol is turned
on.
In the same aggregation group, the member ports that can perform in / out load sharing
must have the same rate, duplex, and basic configuration. The basic configuration includes:
● STP configurations are the same: including STP on / off, link attributes (such as
point-to-point or non-point-to-point), STP priority, STP cost, STP packet format, loop
protection and root protection on the port, Whether it is an edge port or not.
QoS configuration is consistent, including: traffic rate limiting, priority marking, 802.1p
priority, traffic redirection, traffic statistics.
Enter
【
Network Management
】
-
【
Trunking
】
menu bar. In Trunking page, you can enable
/ disable aggregation function, set aggregation parameters, click <Add> button to add
settings, click <Modify> button to modify settings, click <Delete > Button to delete the
setting. After setting, click the button on the bottom of the page to save the configuration.
As shown below:
The interface items are as follows:
Interface item
description
Summary of Contents for 221890
Page 5: ...5 1 3Board Diagram...
