EndRun Tempus LX GPS, User Manual

Page: 56 / 116

T e m p u s L X G P S U s e r M a n u a l 44
C H A P T E R S I X
45 T e m p u s L X G P S U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
antfltmask
This command displays the current setting for the Antenna Fault Mask.
Query:
antfltmask
Tempus LX response:
Antenna Fault is ENABLED
cpuopts
This command displays the current settings for the installed CPU Options.
Query:
cpuopts
Tempus LX response:
CPU Option TIME CODE is installed.
Current Setting = IRIG-B122.
cpuoptsconfig
This command starts an interactive shell script that will allow the root user to change the settings of
any installed CPU Options. The user-selectable options are: 1PPS, AM Code, and Prog TTL.
Set:
cpuoptsconfig
Tempus LX response: Interactive shell script is started.
cpusertime
This command displays the current settings for the optional Serial Time Output.
Query:
cpusertime
Tempus LX response:
Current Serial Time Output Baud Rate Setting = 9600
Current Serial Time Output Format Setting = Sysplex
Current Serial Time Output Parity Setting = Odd
cpusertimeconfig
This command starts an interactive shell script that will allow the root user to change the settings of
the optional Serial Time Output. The user-selectable outputs are the format (Sysplex, Truetime, End-
Run, EndRunX and NENA), the baud rate (4800, 9600, 19200, 57600) and the parity (ODD, EVEN,
or NONE).
Set:
cpusertimeconfig
Tempus LX response: Interactive shell script is started.
eraserootfs_1
This command erases the UPGRADE root file system FLASH partition in preparation for performing
a Linux/NTP subsystem firmware upgrade. See
Appendix B - Upgrading the Firmware
for more
information.
Set:
eraserootfs_1
Tempus LX response: Erase progress as percent is shown.