EndRun Tempus LX GPS, User Manual

Page: 44 / 116

T e m p u s L X G P S U s e r M a n u a l 32
C H A P T E R F I V E
33 T e m p u s L X G P S U s e r M a n u a l
F R O N T - P A N E L K E Y P A D A N D D I S P L A Y
Display and Keypad
Operation
The display is organized like the inverted tree structure shown below:
Traversing the Display Structure
After power initialization the welcome message will appear. Press any key to go to the Time/Status
display, which is described under the heading Detailed Display Descriptions . From the Time/Sta-
tus display, press ENTER (or DOWN arrow) to go to the Main Menu. As illustrated in the diagram
above, several status and setup displays are accessible from the Main Menu. To traverse downward
through the tree use the RIGHT and LEFT arrow keys to highlight a selection and then press ENTER.
To traverse back up the tree press BACK (or UP arrow) to return to the previous display.
Editing
To modify a parameter, traverse to the appropriate display and push EDIT. This will cause the edit
display to appear. Within the edit display, the modifiable parameter value is highlighted. Use UP and
DOWN to scroll through all the possible parameter values. When editing a sequence of numbers,
use LEFT and RIGHT to select other digits. When the parameter is correct, press ENTER to load the
new value. All entered values are stored in non-volatile FLASH and restored after a power cycle. If
you wish to abort the edit process, press BACK. This operation returns you to the previous display
and the parameter will remain unchanged.
Time / Status
Display
Receiver Clock Opt-I/O Display Faults Network NTP Firmware About
Main Menu
System
Fault
Status Network
Address
Setup
Program
Revision
Contact
Information
Display
Intensity /
ScreenSave
Status Ref-Pos GPS Mode Osc-Stat AntFltMask SigFltMask
Receiver Menu
GPS
Receiver
Status
Reference
Position
Status Setup
NTP Menu
NTP
Operation
Status Broadcast
Multicast
Setup
Time-Mode Loc-Offset Hrs-Disp DST
Clock Menu
Time
Mode
Setup
Local
Offset
Setup Hours
Display
Format
Daylight
Savings
Setup
GPS
Dynamic
Mode Oscillator
Status
CPU-I/O OptCard1 OptCard2 OptCard3 OptCard4 OptCard5
Option I/O Menu
Slot5
Plug-in
Option
Info/Setup
Slot4
Plug-in
Option
Info/Setup
Slot3
Plug-in
Option
Info/Setup
Slot2
Plug-in
Option
Info/Setup
Slot1
Plug-in
Option
Info/Setup
PPS-Setup Code-Out ProgTTL Syntheszr SerTimeOut
CPU Module I/O Menu
1PPS
Pulse
Width
Time Code
Output
Format
Prog TTL
Output
Selection
Synthesizer
Rate
Selection
Antenna
Fault
Mask Signal
Fault
Mask
Serial
Time
Format