Endress ESE 406 HG-GT ES DUPLEX, Operating Instructions Manual

Page: 60 / 79

Using special fittings / accessories
60 ESE 406 - 606 (D)HG-GT (ES) Duplex
Status: August 2017
1. Switch off or disconnect consumers.
2. Continue to run the engine for about two minutes.
3. Turn the switch
(Figure 5-4-(1))
to the “Off“ position.

The generator is switched off.

The operation indicator light
(Figure 5-4-(3))
lights up.
Ensure that the engine start switch
(Figure 5-3 - (3))
of the gener-
ator remains in the “OFF“ position. Otherwise the control cir-
cuit on the generator will still be energized which can cause
the starter battery to discharge.
5.3.1
EMERGENCY-STOP switch
In the equipment specification with a remote start device, the
generator is fitted with an EMERGENCY STOP function. In
this way one can ensure that the generator can always be
stopped as quickly as possible in a dangerous situation, or if
there is a fault, over the clearly marked EMERGENCY STOP
switch
(Figure 5-3 - (1))
on the device.
Proceed as follows to switch off the generator in an emer-
gency using the EMERGENCY STOP switch.

The EMERGENCY STOP switch must be available to op-
erate at any time without fulfilment of any requirements.
1.
Actuate the red knob on the EMERGENCY STOP switch
(Figure 5-3 - (1))
by pressing or pounding

The generator is stopped

The line circuit breaker
(Figure 5-2-(4))
triggers (Position 0)

The EMERGENCY STOP switch is locked in the Off po-
sition.
Proceed as follows to switch the generator on again after us-
ing the EMERGENCY STOP switch.
1. Turn knob on the EMERGENCY STOP switch
(Figure 5-3-
(1))
until is springs out of the locked position.
2. Bring the line circuit breaker into Position 1

The EMERGENCY STOP lockout is removed.

The generator can now be started as usual.
Switch off the engine
using remote start
NOTE
Requirements
Trigger the EMERGENCY-
STOP switch
Unlocking the
EMERGENCY-STOP