Endress ESE 406 HG-GT ES DUPLEX, Operating Instructions Manual

Page: 58 / 79

Using special fittings / accessories
58 ESE 406 - 606 (D)HG-GT (ES) Duplex
Status: August 2017
Remote start device
Proceed as follows to operate the generator using the re-
mote start device.
The following requirements must be met, before you connect
the remote start device:

Generator is ready for operation

Engine start switch
(Figure 4-4-(3))
is in the “OFF” position.

All consumer are switched off or disconnected from the
generator.
Figure 5-3: Remote start device
Proceed as follows to connect a cable remote control (not in
the scope of delivery).
1. Remove protective cap of the CPC remote start socket
( Figure 5-3-(2))
counterclockwise.
2. Insert plug of the connecting cable of the cable remote
control in the correct location in the remote start socket.
3. Turn the locking ring of the connector clockwise up to the
stop.
4. Route the connecting cable securely up to the operating
point.

Remote start device is ready for use.
Requirements
Connecting up a remote
start device
1
2 3