Endress ESE 406 HG-GT ES DUPLEX, Operating Instructions Manual

Page: 59 / 79

Using special fittings / accessories
Remote start device
Status at: August 2017
ESE 406 - 606 (D)HG-GT (ES) Duplex 59
Proceed as follows to disconnect a cable remote control.
1. Switch the generator (engine start switch
( Figure 5-3-(3))
into the “OFF” position!
2. Turn the locking ring on the connector counterclockwise
until the lock is released.
3. Pull off connector for connecting cable.
4. Screw the protective cap onto the remote start socket.

Remote start device is disconnected.
Proceed as follows to operate the generator over the remote
start device using cable remote control.
The following requirements must be met:

Generator is ready for operation

Engine start switch
(Figure 5-3-(3))
is in the “OFF” position.

The cable remote control is fitted correctly.
Figure 5-4: Cable remote control
1.
Turn the switch
(Figure 5-4-(1))
to the “On“ position.
2.
Press the “Start-operation” button
(Figure 5-4-(2))
.

The engine is started.
3.
Release the “Start” button
(Figure 5-4-(2))
.

The engine has started.

The operation indicator light
(Figure 5-4-(3))
lights up.
Only activate the starter briefly (max. 5-10 seconds). Never
unclamp the starter battery when the engine is running.
Disconnecting the remote
start device
Operation of the remote
start device
Requirements
Start the engine using
remote start
NOTE
1 2 3