Endress+Hauser RMS621, Operating Manual

Page: 43 / 90

RMS 621 6 Commissioning
Hauser 43
Setup
→
Analogue outputs
The set-up possibilities for the analogue outputs are described in this section. Please note that the
outputs can be used as analogue and pulse outputs, the required signal type can be selected in the
set-up. Dependent on the model (expansion cards) between 2 and 8 outputs are available.
Sub menu
Setup (all parameters)
Æ
Analogue outputs.
Display mask 1 value to 8 values
Please select
Set the number of process values that are to be displayed next
to each other in one window (as a group) in the display. The
size of the characters are dependent on the number of selected
values to be displayed. The more values in a group the smaller
the value characters are shown in the display.
Value1 to 8 Please select Select which process values are to be displayed.
Scrolling display Change of individual groups shown in the display.
Switch time 0 to 99
0
Seconds until the next group is displayed.
Group X Yes
No
Select the groups that are to be scrolled in the display.
Colour change Set up that certain events or faults are signalled by a colour
change in the display (from blue to red)
Alarm set point Yes
No
The display rear illumination colour changes from blue to red
on violation of the preset alarm set points.
Wet steam alarm Yes
No
If the temperature in a sat. steam application gets to within 2%
of the sat. steam curve an alarm message occurs. The display
rear illumination colour changes from blue to red.
Sensor fault Yes
No
Failure of a sensor signal is indicated by a change of rear
illumination colour to red.
Over range Yes
No
If a sensor goes over or under range the rear illumination
changes to red.
Display
OIML display Yes
No
Selection if the counter values are to be displayed according to
the OIML-Standard.
Disp. sum Counter mode
Exponential
Display of the sum counter/totalizers
Counter mode: Sum will be shown with a max. of 10 digits
and then it will roll over.
Exponential: For large values the display will switch to
scientific exponential display.
Contrast 2 to 63
46
Set-up for the display contrast. This set-up takes immediate
effect. The contrast value is stored once the setup has been
exited.
Function (Menu
address) Parameter set-up Description
Identifier Analogue out. 1 to 8 For easier identification the analogue output can be allocated
an identification name. (max. 12 characters).
Terminal B-131, B-133
C-131, C-133
D-131, D-133
E-131, E-133
Not used
Sets the terminals onto which the analogue output signal is to
be transmitted.
Function (Menu
address) Parameter set-up Description