Endress+Hauser Proline t-mass A 150, Operating Instructions Manual, Page: 60 / 134

Commissioning Proline t-mass A 150 HART
60 Hauser
Parameter Description Selection/
User entry
Factory setting
Failure mode Select the value the
current output adopts in
an alarm condition.
Prerequisite: The "FIXED
CURRENT" option was not
selected in the CURRENT
SPAN function (xxxx). • Min. current
• Max. current
• Last valid value
• Actual value
• Defined value Max. current
Failure current Select the current value
the current output adopts
in an alarm condition. Floating point number
with 2 decimal places in
the range3.6 to 22.5 mA 22.5 mA
10.5.5 Configuring the PFS output
In the PFS output submenu, you can configure the values for the current output.
Navigation path
"Setup" menu → Advanced setup →PFS output
Structure of the submenu
PFS output →
Operating mode
Assign pulse
Unit
Pulse value
Pulse width
Failure mode
Invert output signal
Assign frequency
Unit
Minimum frequency value
Maximum frequency value
Value at minimum
frequency
Value at maximum
frequency
Failure mode
Invert output signal
Switch output function (On/Off)
(Diagnostic behavior) Assign diagnostic behavior
(Limit value) Assign limit