Endress+Hauser Proline Promass 83, Operating Instructions Manual

Page: 62 / 118

6 Commissioning Proline Promass 83 FOUNDATION Fieldbus
62 Hauser
6.3.3 Data back-up with “T-DAT SAVE/LOAD”
The “T-DAT SAVE/LOAD” function can be used to store all the settings and parameters of the
device to the T-Dat data storage device.
a0001221-en
Fig. 33: Data back-up with “T-DAT SAVE/LOAD” function
Options
LOAD
Data on the T-DAT data storage device are copied to the device memory (EEPROM). This overwri-
tes any settings and parameters of the device.
SAVE
Settings and parameters are copied from the device memory (EEPROM) to the T-DAT.
CANCEL
Cancels the option selection and returns you to the higher selection level.
Application examples
• After commissioning, the current measuring point parameters can be saved to the T-DAT as a bak-
kup.
• If the transmitter is replaced for some reason, the data from the T-DAT can be loaded into the
new transmitter -(EEPROM).
!
Note!
• If the target device has an older software version, the message
“TRANSM. SW-DAT” is displayed during start-up. Then only the “SAVE” function is available.
• LOAD
This function is only possible if the target device has the same software version as, or a more
recent software version than, the source device.
• SAVE
This function is always available.
+
+
E
+
E
B
QUICK SETUP
1009
HOME-POSITION
T-DAT
SAVE/LOAD
LOAD LOAD CANCEL
YES NO to save? YES NO to save?
Input
is saved
Restart
of the
measuring device
Esc
E
+ -
XXX.XXX.XX