Proline Promag 55 PROFIBUS PA
Troubleshooting
Hauser
117
9.6
Return
The following steps must be taken before returning a flow measuring device to Hauser,
e.g. for repair or calibration:
• Always enclose a duly completed "Declaration of contamination" form. Only then can
Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per EN 91/
155/EEC.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could
contain residues. This is particularly important if the substance is hazardous to health, e.g.
flammable, toxic, caustic, carcinogenic, etc.
!
Note!
You will find a preprinted "Declaration of contamination" form at the back of these Operating
Instructions.
#
Warning!
• Do not return a measuring device if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused
through plastic.
• Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be
charged to the owner-operator.
9.7
Disposal
Please observe the regulations applicable in your country or region.
9.8
Software history
Date
Software version
Changes to software
Documentation
12.2007
PROFIBUS PA
3.05.XX
Introduction of a new PROFIBUS PA I/O board
BA124D/06/en/12.07
71065432
09.2006
PROFIBUS PA
2.03.XX
Original software
BA124D/06/en/09.06
71028541
