Endress+Hauser Proline Promag 51, Operating Instructions Manual

Page: 86 / 124

9 Trouble-shooting Proline Promag 51
86 Hauser
032 S: SENSOR SW DAT
$
: # 032
Sensor:
Error accessing the calibration
values stored in the S-DAT. 1. Check whether the S-DAT is cor-
rectly plugged into the amplifier
board
→
Page 96, 98
2. Replace the S-DAT if it is defec-
tive. Spare parts
→
Page 94
Before replacing the DAT, check
that the new, replacement DAT
is compatible with the measuring
electronics. Check the:
– Spare part set number
– Hardware revision code
3. Replace measuring electronics
boards if necessary.
Spare parts
→
Page 94
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
No. # 1xx
→
Software error
101 S: GAIN ERROR AMP.
$
: # 101
Gain deviation compared to refer-
ence gain is greater than 2%. Replace the amplifier board. Spare
parts
→
Page 94
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
111 S: CHECKSUM TOTAL
$
: # 111
Totalizer checksum error 1. Restart the measuring device
2. Replace the amplifier board if
necessary. Spare parts
→
Page 94
Custody transfer mode:
To eliminate fault (point 2), lead seal
must be broken!
121 S: A / C COMPATIB.
$
: # 121
Due to different software versions,
I/O board and amplifier board are
only partially compatible (possibly
restricted functionality).
!
Note!
– The indication on the display as
notice message appears only for
30 seconds (with listing in “Previ-
ous system condition” function).
– This condition can occur if only
one electronics board has been
exchanged; the extended soft-
ware functionality is not availa-
ble. The previously existing soft-
ware functionality is still working
and the measurement possible.
Module with lower software version
has either to be actualizied by ToF
Tool - Fieldtool Package with the
required software version or the
module has to be replaced.
Spare parts
→
Page 94
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
No. # 2xx
→
Error in DAT / no communication
251 S: COMMUNICATION I/O
$
: # 251
Internal communication error on the
amplifier board. Remove the amplifier board.
Spare parts
→
Page 94
Custody transfer mode:
To eliminate fault, lead seal must be
broken!
No. Error message / Type Cause Remedy / spare part