Memosens CFS51
Mounting
Hauser
21
4. Fit the angle connection, nipple and check valve on the hose connection
5. Screw on the check valve and tighten by hand.
6. Connect the hose for cleaning.
7. Before commissioning the cleaning, check again to ensure that all connections are
firmly seated.
5.2.6
Positioning the solid state reference
‣
Ensure that the serial number of the solid state reference matches your sensor.
1
2
A0046893
17
Fitting the sensor on the solid state reference
1
Installation marking on the sensor
2
Installation marking on the solid state reference
1. Remove the sensor from the assembly → 35.
2. Clean the sensor.
3. Remove the protective cap of the solid state reference.
4. Align the sensor in such a way that the installation marking on the sensor is located
above the installation marking on the solid state reference.
5. Fit the solid state reference onto the sensor until the end stop.
5.3
Post-mounting check
Put the sensor into operation only if the following questions can be answered with "yes":
• Are the sensor and cable undamaged?
• Is the orientation correct?
• Is the sensor installed in the assembly and not suspended from the cable?
