Liquiline System CA80TP
Electrical connection
Hauser
23
4. Route the cables on the rear panel of the device so that they are properly protected.
Cable glands are available for the cable entry.
5
A0030460
5
Cable glands
In the case of order versions with G' and NPT cable glands, the pre-mounted cable glands
with an M
‐
thread must be replaced by the G' or NPT glands enclosed.
This does not affect the M32 hose glands.
For cabinet versions, the cable length is approx. 4.3 m (14.1 ft) from the housing floor.
For analyzer stands, the cable length is approx. 3.5 m (11.5 ft) from the foundation.
The terminal connection is located under an additional protective cover in the upper
section of the device.
5. Use the six screws to secure the electronics compartment cover after connecting.
6. Use the five screws to secure the carrier plate after connecting.
5.2
Connecting the sensors and additional modules
5.2.1
Overview of connection compartment in the controller housing
The controller housing has a separate connection compartment. Release the 6 screws in the
electronics compartment cover (1) to open the compartment:
