Endress+Hauser HART Proline Promass 500, Special Documentation

Page: 46 / 52

Life cycle Proline Promass 500
46 Hauser
• Power unit
• Main electronics module
• I/O-Module
• Terminals
• Connection compartment cover
• Electronics compartment cover
• Seal sets for electronics compartment cover
• Securing clamps for electronics compartment cover
• Cable glands
Installation Instructions: see the Download Area at
www.endress.com .
The replaced component must be sent to Hauser for the purpose of fault analysis if
the device has been operated in a protective system and a device error cannot be ruled out. In
this case, always enclose the "Declaration of Hazardous Material and Decontamination" with
the note "Used as SIL device in protection system" when returning the defective device. Please
also refer to the "Return" section in the Operating Instructions. .
7.7 Modification
Modifications are changes to devices with SIL capability already delivered or installed.
‣
Modifications to devices with SIL capability are usually performed in the Hauser
manufacturing center.
‣
Modifications to devices with SIL capability onsite at the user's plant are possible following
approval by the Hauser manufacturing center. In this case, the modifications must
be performed and documented by an Hauser service technician.
‣
Modifications to devices with SIL capability by the user are not permitted.
7.8 Decommissioning
For detailed information on decommissioning, see the Operating Instructions for the
device →  11