Source container FQG66
Basic safety instructions
Hauser
7
‣
Use original spare parts and accessories from Hauser only.
2.5
Product safety
This measuring device is designed in accordance with good engineering practice to meet
state-of-the-art safety requirements, has been tested, and left the factory in a condition in
which it is safe to operate.
2.6
Basic instructions for use and storage
• Observe applicable regulations and national/international standards.
• Comply with radiation protection regulations when using, storing and working with the
radiometric measuring system.
• When storing and transporting the source container, pay attention to the center of
gravity and weight indicated on the packaging.
• Heed warning signs and observe safety zones.
• Install and operate the device according to the instructions in this document and as
specified by the regulatory authority.
• Never operate or store the device outside the specified parameters.
• When operating and storing the device, protect it against extreme influences (i.e.
chemical products, weather, mechanical impacts, vibrations etc.).
• Always secure the "AUS/OFF" switch position by using the lock pin and padlock.
• Before switching on the radiation, make sure that no-one is in the radiation zone (or
inside the product vessel). The radiation may only be switched ON by properly instructed
staff.
• Do not operate damaged or corroded devices. Seek the advice of the competent radiation
safety officer immediately if damage or corrosion occurs. Follow instructions.
• Conduct the required leak test according to the applicable regulations and instructions.
L
WARNING
The device is exposed to strong vibrations or impact.
‣
At regular intervals, please check that the fastening unit is securely seated and stable
and check the condition of the padlock or the retaining element.
L
CAUTION
The plant is not in proper operating condition.
Radiation can escape.
‣
Check the area around the device for signs of radiation.
‣
Notify the radiation safety officer.
2.7
Hazardous area
NOTICE
The suitability of the radiometric measurement method and of the device for
applications in hazardous areas must be checked by the plant operator according to
the national rules and regulations that apply.
‣
Compliance with national rules and regulations is mandatory.
The following must be observed:
• Avoid electrostatic charge at the device. Do not rub synthetic surfaces dry.
• Avoid friction sparks and impact sparks.
• The device must be integrated in the plant potential equalization system.
