Cerabar S 4 to 20mA HART
Description of parameters
Hauser
23
P01-xxxxxxxx-19-xx-xx-xx-095
Fig. 11:
TRANSMITTER INFO group
For the HART DATA function group, see Page 23, Table 8
For the TRANSMITTER DATA function group, see Page 25, Table 9
For the PROCESS CONNECTION function group, see Page 26, Table 10
For the SENSOR DATA function group, see Page 28, Table 11
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
2)
1)
1)
2)
2)
DIP STATUS
DIAPHRAGM SEAL +
DIAPHRAGM SEAL –
NR OF REMOTE SEAL
FILL FLUID
PCB TEMPERATURE
ALLOWED MIN. TEMP
ALLOWED MAX. TEMP
Tmax SENSOR
SENS H/WARE REV.
MOUNTING THREAD
REMOTE SEAL +
REMOTE SEAL –
DEVICE DESIGN.
HARDWARE REV.
SOFTWARE VERSION
CONFIG RECORDER
MAT. MEMBRANE
FILLING FLUID
Tmin SENSOR
NUTS MATERIAL
DRAIN VENT MAT.
DRAIN VENT POS.
THREAD
ADDITIONAL INFO.
SEAL TYPE
SENSOR MEAS. TYPE
BOLTS MATERIAL
DEVICE REVISION
ELECTR. SERIAL No
CUST. TAG NUMBER
LONG TAG NUMBER
PROC. CONN TYPE
MAT. PROC. CONN. +
MAT. PROC. CONN. –
PRESS. SENS LOLIM
PRESS: SENS HILIM
MINIMUM SPAN
HART DATA
BUS ADRESS
TRANSMITTER INFO
TRANSMITTER DATA
DEVICE SERIAL No
PROCESS CONNECTION
Pmax PROC. CONN.
SENSOR DATEN
SENSOR SER. No.
TOTALIZER SETUP
4TH VALUE IS
4 TH VALUE
SECONDARY VALUE
THIRD VALUE IS
THIRD VALUE
HART DATE
PRIMARY VALUE IS
PRIMARY VALUE
SECONDARY VAL. IS
HART MESSAGE
MANUFACTOR ID
PREAMBLE NUMBER
LANGUAGE
SETTINGS
POSITION ADJUSTMENT
OPERATING MENU
GROUP SELECTION
Measured value
DEVICE TYPE
1) Display via on-site display only
2) Display via digital communication
BURST MODE
BURST OPTION
Table 8: (GROUP SELECTION
) OPERATING MENU
TRANSMITTER INFO
HART DATA
Parameter name
Description
BUS ADDRESS (345)
Entry
Enter the address for the exchange of data with the HART protocol.
(HART 5.0: range 0...15, HART 6.0: range 0...63)
Factory setting:
0
DEVICE TYPE (802)
Display
Displays the device identification number in decimal numerical format,
here Cerabar S: 24
Prerequisite:
• Cerabar S pressure transmitter
DEVICE REVISION (699)
Display
Displays the device revision
