• Patch a variable waveform oscillator into the
AUDIO IN 1
, SAW and SQUARE waves
work best. Feed an additional envelope or LFO to the
pre VCA input
on the GHOST to
create movement. Patch the
AUDIO OUT 1/2
to your mixer
• Set
DELAY DRY/WET
to 80% with
REPEATS
around 3040%, adjust the
REPEATS/tone*
by pressing the
R REPEATS
knob to around 13:00 14:00.
Sync the delay by sending a clock from your sequencer into the
CLOCK IN
and leave
TIME/DIV
knob at 12:00
• Set
REVERB DRY/WET
to 60% with a moderate
TAIL
amount at around 40%. Adjust
the
PREDELAY
by pressing the
R turning the TAIL/predelay* knob
to
approximately 7080%
• Set
DISTORTION
to 20% and
COMPRESSOR
to 70% to bring in some noise
• Send a PITCH sequence to the
VCF CV
input.
COMB
does not track 1v/oct, but this
allows you to highlight frequencies without doubling the amplitude of the fundamental of
the sound source. Set the
FREQUENCY CUTOFF
knob to 11:00 with
VCF CV
attenuverter
fully CW
• Start the sequencer and listen how GHOST creates timbres on top of a steady oscillator
• Patch another
1v/oct PITCH CV
signal to your oscillator and play around with the notes,
you will hear how new ghost harmonies appear, let them direct your next note.
FIRMWARE UPDATE
Firmware updates are essential for any digital modules. They bring new features or
bug fixes.
Feel free to write any bugs, features ideas or improvements to [email protected]
To update the firmware on your Ghost, first download the latest firmware file once
available on Endorphin.es website: https://www.endorphin.es/modules/p/ghost
The update procedure is done via audio: either computer or phone will work, we
advise you to disable all notifications (flight mode) so that the update is not
interrupted.
1.
Power OFF your modular system.
2.
Unplug all the cables from GHOST except a simple mono or stereo cable
connecting the audio output from your computer headphones output to the
‘AUDIO IN 1’
input of the module.
3.
Set the output volume of your computer to 100% or slightly lower.
4.
Hold
ROUTING
while powering your system ON - you will see both
CLIP
and
/
ENV DEPTH
LEDs on.
Summary of Contents for GHOST 16hp
Page 1: ...FIRMWARE V 1 00 RC ...
Page 5: ...INTERFACE ...
